TOYOTA – LEXUS ECU FLASHER with erase, forced write function, some models support OBD read and write mode, with wiring diagram
For Toyota Flasher, a joint project by Autokey and PCMflash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA, LEXUS and SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.
SUPPORT 2015 + OBD WRITE
and SOME MODELS 2015 + OBD READ
can READ and WRITE via internal 20 pin or 26 pin connector.
connection diagram for all known pcb you can find here :
SUPPORTED DEVICES :
TOYOTA DENSO ENGINE CONTROL MODULE
based on NEC 7F00XX series MCU
76F0038
7F0038A
76F0039
76F0039A
76F0040
76F0040A
76F0070 BGA
76F0085 BGA
saving in normal mode
without any master-slave.
master only.
auto CHECKSUM CORRECTION support
Package List:
ECU Flash main unit
Cables
